-20ºC Cold and Chemical Resistant Gloves Hi Vis Orange PVC Cold Handling

  • Product Code: GALASKAGT
  • Availability: Out Of Stock
  • £3.90

    Lowest price
  • £4.68 inc. VAT


  • -20ºC Cold and Chemical Resistant Gloves Hi Vis Orange PVC Cold Handling
1+ 10+ 36+ 72+
£6.72 (£5.60 ex. vat) £5.88 (£4.90 ex. vat) £5.04 (£4.20 ex. vat) £4.68 (£3.90 ex. vat)
Glove Size Qty
Total price: £0.00 £0.00 ex. vat Add to Basket

Alaska Plus High Visibility Orange Double Dipped PVC Chemical and Cold Gauntlet

Although these state size 11 on the glove, because of the insulation they are a size 9.5 inside

12" 30cm Thermal PVC Gauntlet with Triple Layer Foam Padding Insulation giving protection to -20ºC
A brilliant orange, foam insulated glove made from specially formulated PVC which remains flexible at low temperatures.
Extended knitted wrist and soft jersey lining laminated to foam make this an extremely warm and comfortable glove.

Sanitized®: These gloves incorporate a Biocidal product. The Biocidal treatment protects against a
broad spectrum of Bacteria and Fungi.
The active Biocidal substance - Zinc Pyrithione - promotes freshness and inhibits odours.

Typical applications: 
Cold working in oily/wet conditions, cold stores, fishing, offshore.

Mechanical test data in accordance with EN 388

Abrasion   Level 4
 Cut  Level 1
 Tear  Level 2
 Puncture  Level 1

Cold test data in accordance with EN 511

Convective Cold          Level 1
 Contact Cold           Level 1
 Water Impermiability   Level 1



Both new and used gloves should be thoroughly inspected before being worn to ensure no damage is
present. Gloves should not be left in a contaminated condition if reuse is intended in which case gloves
should be cleaned as far as possible. Gloves may be washed with mild detergent then rinsed with clean
water and allowed to dry, ideally with some air movement.ô€€€Care should be taken when removing gloves
to avoid any contaminant contacting bare skin.


When stored as recommended will not suffer change in mechanical properties for up to 5 years from the
date of manufacture. Service life cannot be specified and depends on the application and responsibility
of the user to ascertain the suitability of the glove for the intended use.


The results of physical tests should help in glove selection, however it must be understood that actual
conditions of use cannot be simulated and it is the responsibility of the end user and not the
manufacturer to determine glove suitability for the intended use.