Chemical & Solvent Resistant 66cm 26" PVC Long Sleeved Gauntlet

Redek Chemical Resistant Long Sleeved 26" 65cm Gauntlets that cover all your arm up to the armpit
A tough, smooth PVC gauntlet with an elasticated sleeve attached to the cuff to protect the lower arm. 
Sanitized® hygiene function works to improve freshness, hygiene and odour repellence over extended periods of use. 
Fully REACH compliant and Phthalate free formulation.
NOTE: Not recommended for use with concentrated corrosive liquids.
Typical applications: 
General handling of dilute chemicals, refining, janitorial

TECHNICAL DETAILS

Mechanical test data in accordance with EN 388
Abrasion Resistance Level 4
Cut Resistance Level 1
Tear Resistance Level 2
Puncture Resistance Level 1

GAUNTLET

SLEEVE

These gloves are sampled and tested for leakage in accordance with EN 374-I 
Section 5.1.2 and EN 374-II Section 6.2 respectively and the results at performance 
level 3 and inspection level GI are classified as Acceptable Quality Level (AQL) = 0.65

OTHER INFORMATION

CLEANING /MAINTENANCE

Both new and used gloves should be thoroughly inspected before being worn
to ensure no damage is present.
Gloves should not be left in a contaminated condition if reuse is intended in
which case gloves should be cleaned as far as possible.
Washing of these gloves is not recommended. Gloves may be washed with
mild detergent then rinsed with clean water and allowed to dry, ideally with some air
movement.
Care should be taken when removing gloves to avoid any contaminant contacting bare skin.

OBSOLESCENCE

When stored as recommended will not suffer change in mechanical properties
for up to 5 years from the date of manufacture.
Service life cannot be specified and depends on the application and
responsibility of the user to ascertain the suitability of the glove for the intended use.

PLEASE NOTE

The results of physical tests should help in glove selection,
however it must be understood that actual conditions of use cannot be simulated
and it is the responsibility of the end user and not the
manufacturer to determine glove suitability for the intended use.